NAD M15 HD2 AV Manuel du propriétaire Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
ADJUSTING CHANNEL LEVELS ON THE FLY’
You can make changes to the relative levels of center, surround and
subwoofer outputs without having to go into the ‘Speaker Levels’ menu.
This is very convenient in circumstances like increasing (or tone down)
a lms dialog level by raising (lowering) the center channel or reducing
excessive deep bass (or enhance deep bass) by lowering (raising) the
subwoofer level.
Use the HTRM’s ’SURR, ‘CENT and ‘SUB’ keys for direct-access level
adjustment of these channels over a range of ±6 dB.
The surround back channels (if any) adjust in lockstep with the surround
channels.
NOTE
Levelsettingsadjusted‘OntheFly’areaddedorsubtractedtothesetup
levelsestablishedattheM15HDlevel-calibrationroutineasinvokedby
theHTRM‘Test’key.However,selectinganyPresetwillrevertthechannel
levelstothosestoredinthepreset.ItwillalsotakeM15HDothelevels
setviaAudysseyAutoCalibration.
ZONE SETUP
The Zone feature allows one to simultaneously experience in dierent
zones of the house multiple sound sources from all enabled Sources as well
as from Front Input, Media Player and Tuner.
The M15 HD has three congurable Zones – Zone 2, Zone 3 and Zone 4.
Use a combination of [A/S/D/F] and [ENTER] keys to navigate through the
Zone Setup menu parameters.
VOLUME
Zone 2 have Fixed and Variable volume control. When set to Variable’ and
while at the ‘Zone Controls’ menu OSD, the Zone 2 Volume level can be
adjusted using the HTRM’s [D/F] or directly via ZR 5’s [VOL 5/6].
On the other hand, if Volume is set to ‘Fixed, the Zone 2 Volume is set to
a preset dB level and thereafter the Zone’s volume can be varied via the
volume control of the separate amplier it is fed into.
MODE
Zone 3 and Zone 4 can be congured into two modes - Record Out and
Zone (Audio Only). If the selected mode is “Record out”, the audio of the
assigned Source is directly sent out to the applicable Audio output (See
Item 1 AUDIO 1-7 IN/VIDEO 1-4 IN/S-VIDEO 1-4 IN). When Zone 3 or Zone 4
is set to “Record Out” mode, they will not be available at the “Zone Controls’
section of the Main Menu window.
See discussion also on ‘Zone Controls at the Main Menu.
NOTE
TheZR5remotecontrolwillonlycontrolZone2applications.
OPERATION
USING THE M15 HD  SETUP MENU
23
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Commentaires sur ces manuels

Pas de commentaire